Dell EqualLogic PS5000 - Step 3: Turn on Power to the PS5500

Installation and Setup Installing Array Hardware
2–22
Make sure you use the cable management system to organize the network cables,
along with the power cables. See Figure 2-8 to Figure 2-12.
Step 3: Turn on Power to the PS5500
Before turning on power, make sure the array is at room temperature.
To turn on power and transition the array from standby mode to full-power mode:
1. Insert the bezel key and turn it clockwise to unlock the bezel. See Figure 2-15.
Figure 2-15: Unlocking the Bezel
2. Hold the bezel and push the bezel release latch up to disengage the bezel from
the chassis. See Figure 2-16.
Figure 2-16: Pushing Up the Bezel Release Latch
3. Pull the bezel away from the chassis. See Figure 2-17.