Index-1
Index
A
access controls
protecting volumes
4-1
setting up with CLI 4-2
setting up with GUI 4-4
accounts, configuring after setup 5-1
array, see PS5000 array and PS5500
array
B
bezel
installing
2-23
removing 2-22
C
cable (serial)
connecting to a PS5000
2-11
connecting to a PS5500 2-23
required characteristics 2-11, 2-24
cable management system
installing
2-15
network cable configuration 2-22
power cable configuration 2-17
cables (network)
connecting to a PS5000
2-9
connecting to a PS5500 2-20
supported 2-9, 2-20
cables (power)
connecting to a PS5000
2-8
connecting to a PS5500 2-16
capacity (group), increasing 1-1
CHAP accounts, configuring 5-1
CLI
creating volumes
4-2
setting RAID policy 3-7
computers
accessing volumes
4-1
connecting to volumes 4-5
Flow Control recommendation 2-3
Jumbo Frames recommendation
2-3
control modules
PS5000 support
2-5
PS5500 support 2-14
restriction on mixing 2-5
D
date, setting 5-1
E
electrostatic discharge, avoiding 2-1
electrostatic wrist strap, using 2-1
event notification, configuring 5-1
F
Flow Control recommendation 2-3
full-power mode, defined 2-22
G
Gigabit Ethernet recommendation 2-2
group
accessing volumes from a
computer
4-6
advanced tasks 5-1
creating 3-1, 3-2
customizing after setup 5-1
defined 1-1
expanding 3-1, 3-2
increasing capacity 1-1
IP address 3-3
logging in to CLI 3-7
logging in to GUI 3-8
name 3-3
group IP address, defined 1-2
To Next Page
Loading...
