42 | Smart Scripting CLI
www.dell.com | support.dell.com
username
z
Configure an additional user name and password to be used only to run scripts on a
switch. The user name and password are used to log in to a UNIX shell and apply the
read-write privileges assigned to the user name when a script is run.
Syntax
username name password password
Enter no username to remove the user name and password.
Defaults
none
Parameters
Command Modes
CONFIGURATION
Command
History
Usage
Information
When you run a script from the FTOS CLI with the script command, you can specify
an optional user name to apply the read-write privileges assigned to the user name
when the script is run (see Running a Script from the FTOS CLI).
name Enter a username to access the UNIX shell. The user name must be
less than 16 characters to satisfy the BSD UNIX login requirements.
A username used to run scripts cannot contain special characters.
password password Enter a password to access the UNIX shell.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Version 8.3.5.1 Introduced on the S55.
Version 8.3.3.4 Introduced on the S60.
To Next Page
Loading...
Need help?
General
