Virtual Server Networking CLI | 65
show virtualswitch
Display the components of current hypervisor sessions, including the virtual switch
and name of the hypervisor session to which a switch interface is connected,
Syntax
show virtualswitch [interface] [virtualswitch-name]
Defaults
None
Parameters
Command Modes
EXEC Privilege
Command
History
Usage
Information
Use the show virtualswitch command to display the interface, virtual-switch name,
and hypervisor-session name for all current hypervisor connections on the switch.
To display detailed information on a hypervisor session, re-enter the command with
the interface and virtual-switch name for the session from the
show virtualswitch
output as shown in the example below.
Example
The following command output displays information on the hypervisor sessions
established on all virtual switches on network servers connected to switch interfaces.
FTOS#show virtualswitch
Interface VSwitch Hypervisor
Gi 0/32 vSwitch3 VMWare_vmware207
Po 7 vSwitch1 VMWare_vmware206
interface Display information on the hypervisor session established on a
specified interface. Enter one of the following interface types:
• For a 100/1000 Ethernet interface or 1-Gigabit Ethernet interface,
enter: GigabitEthernet slot/port
• For a 10-Gigabit Ethernet interface, enter:
TenGigabitEthernet slot/port
• For a port-channel interface, enter: port-channel number
Where the valid port-channel numbers are 1 to 128.
virtualswitch-name Display information on a specified virtual switch by entering the
name generated by the hypervisor.
Version 8.3.8.0 Introduced on the S4810.
Version 8.3.5.1 Introduced on the S55.
Version 8.3.3.4 Introduced on the S60.
To Next Page
Loading...
Need help?
General
