Dell Force10 S4810P - Configure a Management Route; Configure a Username and Password

16 Installing the Software
Configure a Management Route
Define a path from the system to the network from which you are accessing the
system remotely. Management routes are separate from IP routes and are only
used to manage the system through the management port.
Configure a Username and Password
Configure a system username and password to access the system remotely.
Step Task Command Syntax Command Mode
1 Enter INTERFACE
mode for the
Management port.
interface ManagementEthernet
slot/port
CONFIGURATION
2 Assign an IP address
to the interface.
ip address ip-address/mask INTERFACE
3 Enable the interface. no shutdown INTERFACE
Task Command Syntax Command Mode
Configure a
management route to
the network from
which you are
accessing the system.
management route ip-address/mask
gateway
CONFIGURATION
Task Command Syntax Command Mode
Configure a username
and password to
access the system
remotely.
username username password
[encryption-type]
CONFIGURATION