Dell Force10 S55 - Page 35

Access the console ports | 35
2 Connect the USB-A end of cable (supplied) into an available USB port on the PC
3 Connect the USB-B end of cable into the USB-B console port on the S55 (
4 Power on the S55.
5 Install necessary USB device drivers (internet connection required).
Contact Dell Force10 Networks Technical Support for assistance if necessary.
6 Open your terminal software emulation program to access the S55.
7 Using the terminal settings shown here, set the terminal connection settings.
• 9600 baud rate, No parity, 8 data bits, 1 stop bit, No flow control
8 The CLI command prompt appears (shown below) when you are connected to the S55.
Step Task (continued)