NOTE: If either the system board or the heat sink is replaced, use the thermal pad/paste provided in the kit to ensure that
thermal conductivity is achieved.
Steps
1 Place the heat sink on the system board and align the screw holes on the heat sink with the screw holes on the system board.
2 In sequential order (as indicated on the heat sink), tighten the eight captive screws that secure the heat sink to the system board.
3 Adhere the tape to the heat sink to secure it to the system board.
Next step
1 Install the battery.
2 Install the base cover.
3 Follow the procedure in After working inside your computer.
Identifier GUID-E3C0201A-5B16-4C16-BB92-B961F39AE9F4
Status Released
Fans
30
Removing and installing components
To Next Page
Loading...
