Steps
1 Place the palm-rest and keyboard assembly on a at surface near the edge.
2 Align and place the display assembly perpendicularly onto the palm-rest and keyboard assembly.
3 Install the four screws (M2.5x5) to secure the display hinges to the system board.
4 Connect the display cable on to the connector on the system board.
5 Close the display.
Next step
1 Install the WLAN card.
2 Install the battery.
3 Install the base cover.
4 Follow the procedure in After working inside your computer.
Removing and installing components
45
To Next Page
Loading...
