Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Screw image
Base cover M2x4 Downfiring speakers: 6
Upfiring speakers: 5
Base cover Captive screws
NOTE: Screws are
part of the base
cover.
2
3-cell battery M2x3 3
4-cell battery M2x3 5
M.2 2230 solid-state drive
(SSD) extension bracket
M2x3
M2x1.8
1
1
M.2 2280 solid-state drive
(SSD)
M2x3 1
Wireless-card bracket M2x3 1
2
10 Removing and installing components
To Next Page
Loading...
