Steps
1. Place the power button in the slot on the palm-rest and keyboard assembly.
2. Align the screw hole on the power button to the screw hole on the palm-rest and keyboard assembly.
3. Replace the screw (M2x3) to secure the power button to the palm-rest and keyboard assembly.
Next steps
1. Install the I/O daughter-board.
2. Install the I/O daughter-board cable.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Power button with optional fingerprint reader
Removing the power button with optional fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the I/O daughter-board cable.
4. Remove the I/O daughter-board.
About this task
NOTE: For computers shipped with a fingerprint reader, the power button includes a fingerprint reader module.
The following image indicates the location of the power button with optional fingerprint reader and provides a visual
representation of the removal procedure.
50
Removing and installing components
To Next Page
Loading...
