Steps
1. Align and place the touchpad, along with the touchpad flexible flat cable, in the slot on the palm-rest and keyboard assembly.
2. Align the screw holes on the touchpad to the screw holes on the palm-rest and keyboard assembly.
3. For computers shipped with downfiring speakers, replace the two screws (M2x2) and the four screws (M1.6x2.5) to secure
the touchpad to the palm-rest and keyboard assembly.
4. For computers shipped with upfiring speakers, replace the four screws (M2x2) and the five screws (M1.6x2.5) to secure the
touchpad to the palm-rest and keyboard assembly.
5. Connect the touchpad flexible flat cable to the connector on the system board and close the latch.
6. Adhere the tape to secure the touchpad to the palm-rest and keyboard assembly.
Next steps
1. Install the 3-cell battery or the 4-cell battery, whichever applicable.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the removal
procedure.
40
Removing and installing components
To Next Page
Loading...
