Steps
1. Connect the I/O daughter-board cable to the connector on the I/O daughter-board and close the latch.
2. Adhere the tape to secure the I/O daughter-board cable to the connector on the I/O daughter-board.
3. Carefully route the I/O daughter-board cable through the routing guides on palm-rest and keyboard assembly.
4. Connect the I/O daughter-board cable to the connector on the system board and close the latch.
5. Adhere the tape to secure the I/O daughter-board cable to the connector on the system board.
6. Adhere the tape to secure the I/O daughter-board cable to the fan.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
I/O board
Removing the I/O daughter-board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the I/O daughter-board cable.
About this task
The following images indicate the location of the I/O daughter-board and provide a visual representation of the removal
procedure.
44
Removing and installing components
To Next Page
Loading...
