Steps
1. Connect the battery cable to the connector on the system board.
2. Adhere the tape to secure the battery cable to the connector on the system board.
3. Place the base cover on top of the palm-rest and keyboard assembly.
4. Align the screw holes on the base cover to the screw holes on the palm-rest and keyboard assembly, and snap the base
cover latches into place.
5. Tighten the two captive screws to secure the base cover to the palm-rest and keyboard assembly.
6. For computers shipped with downfiring speakers, replace the six screws (M2x4) to secure the base cover to the palm-rest
and keyboard assembly.
7. For computers shipped with upfiring speakers, replace the five screws (M2x4) to secure the base cover to the palm-rest and
keyboard assembly.
Next steps
1. Follow the procedure in After working inside your computer.
Battery
Lithium-ion battery precautions
CAUTION:
● Exercise caution when handling Lithium-ion batteries.
Removing and installing components 17
To Next Page
Loading...
