Steps
1. Loosen the four captive screws that secure the integrated heat sink to the system board.
NOTE:
Loosen the four captive screws in the reverse sequential order mentioned on the integrated heat sink [4 > 3 > 2
> 1].
2. Lift and remove the integrated heat sink from the system board.
Installing the heat sink - integrated
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
If either the system board or the heat sink is replaced, use the thermal grease provided in the kit to ensure that
thermal conductivity is achieved.
The following image indicates the location of the integrated heat sink and provides a visual representation of the installation
procedure.
Removing and installing components
31
To Next Page
Loading...
