Steps
1. Place the fan on the palm-rest and keyboard assembly.
2. Align the screw holes on the fan to the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x3) to secure the fan to the palm-rest and keyboard assembly.
4. Connect the fan cable to the connector on the system board.
5. Adhere the tape to secure the I/O daughter-board cable to the fan.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Heat sink
Removing the heat sink - integrated
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
NOTE: For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin
can reduce the heat transfer capability of the thermal grease.
The following image indicates the location of the integrated heat sink and provides a visual representation of the removal
procedure.
30
Removing and installing components
To Next Page
Loading...
