Steps
Place the palm-rest and keyboard assembly on a clean and flat surface.
Next steps
1. Install the touchpad.
2. Install the system board.
NOTE:
The system board can be removed with the heat sink attached to avoid breaking the thermal bond between the
heat sink and the system board.
3. Install the display assembly.
4. Install the power button or the power button with fingerprint reader, whichever is applicable..
5. Install the fan.
6. Install the speakers.
7. Install the I/O board.
8. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever is applicable.
9. Install the wireless card.
10. Install the coin-cell battery.
11. Install the battery.
12. Install the base cover.
13. Follow the procedure in After working inside your computer.
74
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
