Dell Inspiron 14-7472 - Replacing the Display Assembly

Replacing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Place the palm rest and keyboard assembly on the edge of a table with the
keyboard facing down.
2 Align the screw holes on the display hinges with the screw holes on the palm rest
and keyboard assembly.
3 Replace the four screws (M2.5x5) that secure the display assembly to the palm
rest and keyboard assembly.
4 Close the display and turn the computer over.
5 Slide the display cable into the connector on the system board and close the
latch to secure the cable.
6 Route the antenna cables through the routing guides on the fan.
Post-requisites
1 Replace the wireless card.
2 Replace the battery.
3 Replace the base cover.
48