Removing the power-adapter
port
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
3 Remove the memory module.
4 Remove the wireless card.
5 Remove the fan (for computer with integrated graphics card)
6 Remove the heat sink (for computer with integrated graphics card).
7 Remove the heat-sink assembly (for computer with discrete graphics card).
8 Remove the solid-state drive.
9 Follow the procedure from step 1 to step 2 in “Removing the hard drive”.
10 Remove the system board.
11 Remove the display assembly.
Procedure
1 Note the power-adapter port cable routing and remove it from the routing guides
on the palm rest and keyboard assembly.
2 Remove the screw (M2x3) that secures the power-adapter port to the palm rest
and keyboard assembly.
75
To Next Page
Loading...
