Input/Output board
Removing the Input/Output board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
About this task
The following images indicate the location of the Input/Output board and provides a visual representation of the removal
procedure.
Steps
1. Remove the two (M2.5x5) screws that secure the display hinge to the palmrest and keyboard assembly.
2. Lift the hinge up to access the I/O board.
3. Open the latch and disconnect the fingerprint reader board cable from the I/O board.
4. Open the latch and disconnect the I/O board cable from the I/O board.
5. Remove the three (M2x3) screws that secure the I/O board to the palmrest and keyboard assembly.
6. Lift the I/O board off the palmrest and keyboard assembly.
Installing the Input/Output board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
Removing and installing components
27
To Next Page
Loading...
