7. Press down on the display bezel and snap the display bezel in place.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the wireless card.
4. Install the base cover.
5. Install the SD card.
6. Follow the procedure in After working inside your computer.
Camera
Removing the camera module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the display panel.
About this task
The following images indicate the location of the camera module and provides a visual representation of the removal procedure.
Steps
1. Using the pull tab, disconnect the camera cable from the camera module.
2. Using a plastic scribe, pry the camera module from the display assembly.
NOTE: Start prying the camera module in a sequential order 1>2>3 as indicated on the display back cover.
3. Lift the camera module from the display assembly.
60
Removing and installing components
To Next Page
Loading...
