Steps
1. Place the fan on the palmrest and keyboard assembly.
2. Connect the fan cable to the connector on the system board.
3. Align the screw holes on the fan to the screw holes on the palmrest and keyboard assembly.
4. Replace the two screws (M2x5) that secure the fan to the palmrest and keyboard assembly.
Next steps
1. Install the base cover.
2. Install the SD card.
3. Follow the procedure in After working inside your computer.
Power button
Removing the power button
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the IO board.
About this task
The following images indicate the location of the power button and provides a visual representation of the removal procedure.
38
Removing and installing components
To Next Page
Loading...
