Steps
1. Using the alignment post, place the power-adapter port into its slot on the palmrest and keyboard assembly.
2. Connect the power-adapter port cable to the connector on the system board.
3. Fold the right hinge down and install the two (M2.5x5) screws to secure it to the palmrest and keyboard assembly.
Next steps
1. Install the base cover.
2. Install the SD card.
3. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palmrest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the M.2 2230 solid-state drive.
6. Remove the M.2 2280 solid-state drive.
7. Remove the wireless card.
8. Remove the I/O board.
9. Remove the hard drive assembly.
10. Remove the memory modules.
11. Remove the speakers.
12. Remove the heat sink.
13. Remove the fan.
14. Remove the power button.
15. Remove the display assembly.
Removing and installing components
69
To Next Page
Loading...
