2. Replace the single (M2x2) screw that secures the system board to the palmrest.
3. Replace the three (M2x3) screws that secures the system board to the palmrest.
4. Connect the following cables to the system board:
a. I/O board Flexible Flat cable
b. Speaker cable
c. Hard drive Flexible Flat cable
d. Touchpad Flexible Flat cable
e. Keyboard backlight Flexible Printed cable
f. Keyboard Flexible Printed cable
g. Power adapter port cable
h. Display cable
5. Fold back the right hinge and replace the two (M2.5x5) screws to secure it to the palmrest.
Next steps
1. Install the wireless card.
2. Install the heat sink.
3. Install the fan.
4. Install the memory modules.
5. Install the M.2 2230 solid-state drive.
6. Install the M.2 2280 solid-state drive.
7. Install the battery.
8. Install the base cover.
9. Install the SD card.
10. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
About this task
The following images indicate the location of the power-adapter port and provides a visual representation of the removal
procedure.
Removing and installing components
67
To Next Page
Loading...
