Steps
1. Remove the four (M2.5x5) screws that secure the display hinges to the palmrest and keyboard assembly.
2. Disconnect the display cable and the speaker cable from the system board.
3. Unroute the speaker cable from the routing guides on the palmrest and keyboard assembly.
4. Unroute the WLAN antenna cables from the routing guides on the palmrest and keyboard assembly.
5. Open the display assembly to a 120 degrees and flip over the system, and place the system on a flat surface.
6. Remove the display assembly from the palmrest and keyboard assembly.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display assembly and provides a visual representation of the installation
procedure.
Removing and installing components
45
To Next Page
Loading...
