Steps
1. Align and place the left hinge on the display assembly.
2. Install the three (M2.5x3.8) screws to secure the hinge to the display panel and back cover.
3. Align and place the right hinge on the display assembly.
4. Install the three (M2.5x3.8) screws to secure the hinge to the display panel and back cover.
Next steps
1. Install the display bezel.
2. Install the hinge caps.
3. Install the display assembly.
4. Install the WLAN card.
5. Install the base cover.
6. Install the SD card.
7. Follow the procedure in after working inside your computer.
Removing and installing components
55
To Next Page
Loading...
