Removing the display back-cover
and antenna assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
3 Remove the wireless card.
4 Remove the rear cover.
5 Remove the computer base.
6 Remove the display assembly.
7 Remove the display bezel.
8 Remove the display hinges.
9 Remove the display panel.
10 Remove the display cable.
11 Remove the camera.
Procedure
1 Peel the tape that secures the camera cable to the display back-cover and
antenna assembly.
2 Note the antenna-cable routing and remove the camera cable from the routing
guides on the display back-cover and antenna assembly.
117
To Next Page
Loading...
