Replacing the rear cover
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Slide the tabs on the rear cover into the slots on the computer base and snap
the rear cover into place.
2 Align the screw holes on the rear cover with the screw holes on the computer
base.
3 Replace the four screws (M2x2) that secure the rear cover to the computer
base.
Post-requisites
Replace the base cover.
43
To Next Page
Loading...
