Replacing the ngerprint-reader
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align the ngerprint reader daughter-board on the palm-rest assembly.
2 Align the ngerprint reader daughter-board bracket on the palm-rest assembly.
3 Replace the two screws (M2x2) that secure the ngerprint reader daughter-
board to the palm-rest assembly.
Post-requisites
1 Replace the computer base.
2 Replace the rear cover.
3 Replace the battery.
4 Replace the base cover.
82
To Next Page
Loading...
