Replacing the touchpad
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Slide the touchpad under the touchpad bracket.
NOTE: Ensure that the touchpad is aligned with the guides available on
the palm-rest assembly, and the gap on either sides of the touchpad is
equal.
2 Align the screw holes on the touchpad with the screw holes on the palm-rest
assembly.
3 Replace the four screws (M2x2) that secure the touchpad to the palm-rest
assembly.
Post-requisites
1 Replace the computer base.
2 Replace the rear cover.
3 Replace the battery.
4 Replace the base cover.
85
To Next Page
Loading...
