3 Open the latch and disconnect the status-light board cable from the system
board.
4 Disconnect the power-adapter port cable from the system board.
5 Turn the computer base over.
6 Remove the two screws (M2.5x5) that secure the power-adapter port bracket
to the computer base.
7 Lift the power-adapter port bracket o the computer base.
8 Remove the two screws (M2.5x5) that secure the USB Type-C port bracket to
the system board.
9 Lift the USB Type-C port bracket from the system board.
59
To Next Page
Loading...
