Steps
1. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
2. Replace the four screws (M2x3.5) that secure the battery to the palm-rest and keyboard assembly.
3. Connect the battery cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the 6-cell battery (86 Wh)
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: This procedure only applies to computers shipped with a 6-cell battery (86 Wh) installed.
The following image(s) indicate the location of the 6-cell battery (86 Wh) and provides a visual representation of the removal
procedure.
Removing and installing Field Replaceable Units (FRUs)
49
To Next Page
Loading...
