2. Using the pull tab, disconnect the speaker-board cable from the system board.
3. Remove the speaker-board cable from the routing guides on the palm-rest and keyboard assembly.
4. Lift the latch and disconnect the touchpad cable from the system board.
5. Lift the latch and disconnect the keyboard cable from the system board.
6. Lift the latch and disconnect the keyboard-backlight cable from the system board.
7. Disconnect the speaker cables from the connector on the system board.
8. Remove the speaker cables from the routing guides on the palm-rest and keyboard assembly.
9. Lift the left and right speakers along with their cables off the palm-rest and keyboard assembly.
Installing the speakers
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the speakers and provides a visual representation of the installation procedure.
64 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
