Steps
1. Using the alignment posts, place the left and right speakers on the palm-rest and keyboard assembly.
2. Route the speaker cables through the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cables to the connector on the system board.
4. Route the speaker-board cable through the routing guides on the palm-rest and keyboard assembly.
5. Connect the speaker-board cable to the connector on the speaker board.
6. Connect the speaker-board cable to the connector on the system board.
7. Connect the touchpad cable to the system board and close the latch.
8. Connect the keyboard cable to the system board and close the latch.
9. Connect the keyboard-backlight cable to the system board and close the latch.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Touchpad
Removing the touchpad
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 4-cell battery (64 Wh) or the 6-cell battery (86 Wh), whichever is applicable.
About this task
The following image(s) indicate the location of the touchpad and provides a visual representation of the removal procedure.
Removing and installing Field Replaceable Units (FRUs)
65
To Next Page
Loading...
