Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Power button with fingerprint reader
Removing the power button with fingerprint reader
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with a power button with fingerprint reader.
The following image(s) indicate the location of the power button with fingerprint reader and provides a visual representation of
the removal procedure.
60
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
