Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: This procedure applies only to computers shipped with a standard power button.
The following image(s) indicate the location of the power button and provides a visual representation of the installation
procedure.
Steps
1. Insert the power button into the slot on the palm-rest and keyboard assembly.
2. Align the screw holes on the power-button board with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x3) that secure the power-button board to the palm-rest and keyboard assembly.
4. Connect the power-button board cable to the I/O board and close the latch.
5. Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the palm-rest and
keyboard assembly.
6. Replace the two screws (M2.5x5) and the screw (M2x4) that secure the left display hinge to the palm-rest and keyboard
assembly.
Removing and installing Field Replaceable Units (FRUs)
59
To Next Page
Loading...
