Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest
and keyboard assembly.
NOTE:
Brackets are required on the palm-rest and keyboard assembly for computer configuration with the 4-cell battery
(64 Wh). If the palm-rest and keyboard assembly is replaced, transfer the brackets to the new palm-rest and keyboard
assembly.
Next steps
1. Install the touchpad.
2. Install the display assembly.
3. Install the speakers.
4. Install the speaker board.
5. Install the power button or the power button with fingerprint reader, whichever is applicable.
6. Install the system board.
NOTE: The system board can be replaced with the heat sink pre-attached.
7. Install the I/O board.
8. Install the coin-cell battery.
9. Install the fan.
10. Install the wireless card.
11. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive , whichever is applicable.
12. Install the 4-cell battery (64 Wh) or the 6-cell battery (86 Wh), whichever is applicable.
13. Install the base cover.
14. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
79
To Next Page
Loading...
