Steps
1. Lift the Mylar covering the memory module.
2. Using your fingertips, carefully spread apart the securing clips on each end of the memory-module slot (DIMM1) until the
memory module pops up.
3. Remove the memory module from the memory-module slot (DIMM1) on the system board.
NOTE: Repeat step 1 to step 3 for the memory module that is installed in the memory-module slot (DIMM2) on the
system board.
Installing the memory module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the memory module and provides a visual representation of the installation
procedure.
Figure 20. Installing the memory module
Removing and installing Customer Replaceable Units (CRUs)
45
To Next Page
Loading...
