Installing the speakers (down-firing)
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: The left and right speakers cannot be separated for individual replacement. When either speaker needs to be
replaced, services will dispatch the speaker assembly as a single serviceable component.
The following image(s) indicate the location of the down-firing speakers and provides a visual representation of the installation
procedure.
Figure 30. Installing the speakers
Steps
1. Using the alignment posts, place the down-firing speakers on the palm-rest and keyboard assembly.
NOTE: Ensure that the four rubber grommets are seated into the slot and installed correctly on the speakers.
56 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
