NOTE: This step is only applicable for computers that are shipped with the power button with an optional fingerprint
reader.
2. Lift the power button off the palm-rest and keyboard assembly.
Installing the power button
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: If either the system board or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure
that thermal conductivity is achieved.
NOTE: Depending on the configuration of your computer, you may have a power-button with an optional fingerprint reader
installed.
The following image(s) indicate the location of the power button and provides a visual representation of the installation
procedure.
Figure 50. Installing power button with an optional fingerprint reader
Removing and installing Field Replaceable Units (FRUs)
75
To Next Page
Loading...
