About this task
The following image(s) indicate the location of the processor fan and provides a visual representation of the removal procedure.
Figure 23. Removing the processor fan
Steps
1. Disconnect the processor fan cable from its connector (FAN1) on the system board.
2. Remove the two screws (M2x5) that secure the processor fan to the palm-rest and keyboard assembly.
3. Lift the processor fan off the palm-rest and keyboard assembly.
Installing the processor fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the processor fan and provides a visual representation of the installation
procedure.
48
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
