Installing the heat sink
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: If either the system board or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure
that thermal conductivity is achieved.
The following image(s) indicate the location of the heat sink and provides a visual representation of the installation procedure.
Figure 42. Installing the heat sink
Figure 43. Installing the heat sink
Steps
1. Place the heat sink on the palm-rest and keyboard assembly.
68
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
