2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information, see step 6 in Before working inside your
computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the speakers.
5. Remove the graphics procesing unit fan.
6. Remove the processor fan.
7. Remove the heat sink.
8. Remove the wireless card.
9. Remove the display assembly.
10. Remove the system board.
NOTE: The system board can be removed with the heat sink attached.
11. Remove the power-adapter port.
12. Remove the I/O board.
13. Remove the power button.
14. Remove the I/O-board cable.
15. Remove the audio board.
16. Remove the touchpad.
About this task
The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the
removal procedure.
88
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
