About this task
The following image(s) indicate the location of the audio-board cable and provides a visual representation of the removal
procedure.
Figure 38. Removing the audio-board cable
Steps
1. Lift the latch and disconnect the audio-board cable from its connector (IOBD1) on the audio board.
2. Lift the latch and disconnect the audio-board cable from its connector (IOBD2) on the system board.
3. Remove the audio-board cable from the palm-rest and keyboard assembly.
Installing the audio-board cable
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the audio-board and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
65
To Next Page
Loading...
