Steps
1. Align the screw holes on the I/O cover with the screw holes on the display-assembly base and snap the I/O cover back into
place.
2. Replace the five screws (M3x5) that secure the I/O cover to the display-assembly base.
Next steps
1. Install the back cover.
2. Install the stand.
3. Follow the procedure in After working inside your computer.
Display hinges
Removing the display hinges
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
NOTE:
For replacement of stand or hinges, the replacement kit is shipped with both stand and hinges, and the service technician
must replace both of these components together. For more information about removing or installing the stand, see
removing the stand and installing the stand.
About this task
The following image indicates the location of the hinges and provides a visual representation of the removal procedure.
Removing and installing components
19
To Next Page
Loading...
