Installing the microphones
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the microphones and provides a visual representation of the installation procedure.
Steps
1. Align the microphone modules (2) with their slots on the display-assembly base.
2. Replace the four screws (M2X2.5) that secure the microphone modules to the display-assembly base.
3. Route the microphone cable through the routing guides on the display-assembly base .
4. Adhere the tape that secures the microphone cable to the display-assembly base.
Next steps
1. Install the system board.
2. Install the media-card reader.
3. Install the heat sink.
4. Install the fan.
5. Install the wireless card.
6. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive.
7. Install the hard drive.
8. Install the memory module.
9. Install the system-board shield.
10. Install the I/O cover.
11. Install the back cover.
12. Install the stand.
13. Follow the procedure in After working inside your computer.
56
Removing and installing components
To Next Page
Loading...
