Dell Inspiron 27 7710 All-in-One - Installing the Display Hinges

Steps
1. Remove the 10 screws (M3x5) that secure the right and left display hinges to the display-assembly base.
2. Lift the right and left hinges off the display-assembly base.
Installing the display hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
For replacement of stand or hinges, the replacement kit is shipped with both stand and hinges, and the service technician
must replace both of these components together. For more information about removing or installing the stand, see
removing the stand and installing the stand.
The following image indicates the location of the hinges and provides a visual representation of the installation procedure.
20
Removing and installing components