Steps
1. Remove the five screws (M3x5) that secures the left-display hinge to the display-assembly base.
2. Remove the screw (M3x5) that secures the power-button board to the display-assembly base.
3. Peel the tape that secures the power-button board cable to the power-button board.
4. Gently lift the power-button board from the tabs on the display-assembly base.
5. Open the latch and disconnect the power-button board cable from the power-button board.
6. Lift the power-button board off the display-assembly base.
Installing the power-button board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the power-button board and provides a visual representation of the installation
procedure.
46
Removing and installing components
To Next Page
Loading...
