Installing the retractable-camera assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the retractable-camera assembly and provides a visual representation of the
installation procedure.
Steps
1. Slide and place the retractable-camera assembly on the display-assembly base.
2. Replace the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
3. Route the camera cable through the routing guide on the display-assembly base.
4. Adhere the tape that secures the camera cable to the display-assembly base.
5. Connect the camera cable to the system board.
Next steps
1. Install the system-board shield.
2. Install the I/O cover.
3. Install the back cover.
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Fan
Removing the fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
Removing and installing components
35
To Next Page
Loading...
