Steps
1. Align the screw holes on the fan with the screw holes on the display-assembly base.
2. Replace the three screws (M2x2.5) that secure the fan to the display-assembly base.
3. Route the fan cable through the routing guide on the display-assembly base.
4. Connect the fan cable to the system board.
Next steps
1. Install the system-board shield.
2. Install the I/O cover.
3. Install the back cover.
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board shield.
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
Removing and installing components
37
To Next Page
Loading...
