3. Install the back cover.
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Retractable-camera assembly
Removing the retractable-camera assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board shield.
About this task
The following image indicates the location of the retractable-camera assembly and provides a visual representation of the
removal procedure.
Steps
1. Disconnect the camera cable from the system board.
2. Peel the tape that secures the camera cable to the display-assembly base.
3. Remove the camera cable from the routing guide on the display-assembly base.
4. Remove the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
5. Remove the retractable-camera assembly from the display-assembly base.
34
Removing and installing components
To Next Page
Loading...
